User manual ZANUSSI ZFK26/11LR

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual ZANUSSI ZFK26/11LR. We hope that this ZANUSSI ZFK26/11LR user guide will be useful to you.


ZANUSSI ZFK26/11LR : Download the complete user guide (647 Ko)

You may also download the following manuals related to this product:

   ZANUSSI ZFK26/11LR (669 ko)

Manual abstract: user guide ZANUSSI ZFK26/11LR

Detailed instructions for use are in the User's Guide.

[. . . ] Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Important: if the supply cable is damaged, it must be replaced by a special cable available from your local Service Force Centre. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Whenever possible, the back of the appliance should be close to a wall but leaving the required distance for ventilation as stated in the installation instructions. [. . . ] Fill the tray(s) 3/4 full to give the ice space to expand and place them in the freezer compartment. Do not use sharp or metallic instruments to remove the trays from the freezer. 5 Movable shelves The walls of the refrigerator have runners so that shelves can be positioned as desired. D338 Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be adjusted in height. To do this proceed as shown in the diagram. 6 HINTS AND TIPS Normal Operating Sounds · You may hear faint gurgling or bubbling sounds when the refrigerant is pumped through the coils or tubing at the rear, to the cooling plate/evaporator. When the compressor is on, the refrigerant is being pumped round, and you will hear a whirring sound or pulsating noise from the compressor. A thermostat controls the compressor, and you will hear a faint 'click' when the thermostat cuts in and out. Energy Saving Advice · · Do not install the appliance close to sources of heat, such as a boiler or radiator. Locate the appliance in a cool well ventilated room and make sure that the air openings of the appliance are not obstructed. Avoid unnecessary frosting in the cabinet by packing all foodstuffs into airtight packages before placing them in the freezer. Always leave warm food to cool down to room temperature before placing in the fridge. Food which is to be frozen (when cool) should be placed in the fridge before being transferred to the freezer. This will ensure safer defrosting of foods and reduce the work of the refrigeration unit. Try to avoid keeping the door open for long periods or opening the door too frequently as warm air will enter the cabinet and cause the compressor to switch on unnecessarily often. After letting the appliance run for at least half an hour, replace the previously removed food into the compartment. Important When defrosting the freezer, the fridge is also controlled by the thermostat and will not be operational during this period. A temperature rise of the frozen food packs, during defrosting, may shorten their safe storage life. 9 SOMETHING NOT WORKING Important: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation a charge will be made, even if the appliance is under guarantee. Before contacting your local Service Force Centre, check the following points: Symptom No power to the appliance Solution Check there is power at the socket. Check the fuse has not blown. The light does not come on Ensure that the bulb is correctly fitted. Check the door light switch is not jammed. The temperature in the fridge or freezer section is too high Check the thermostat control knob in the fridge is turned to the correct setting relative to ambient conditions. Check the ambient temperature is within the appliance's operating limits, please refer to the installation section in this instruction book. Relocate the appliance if necessary. The freezer door will not open The compressor runs continously Has door just been opened?Adjust the thermostat control knob to give correct temperature control. Large quantities of food have recently been placed in the cabinet and/or door is frequently opened. Check that air ventilation is not obstructed. Excessive frost and ice has built up Ensure the doors are not left open. Has advised periodic defrosting been carried out. Noise Water under the salad crispers Refer to normal operating sounds. [. . . ] To do this, refer to instructions on "Door reversal". Important IF YOU ARE DISCARDING AN OLD APPLIANCE THAT HAS A LOCK OR CATCH ON THE DOOR, YOU MUST ENSURE THAT IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE. Positioning This appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rating plate, which is located at the left on the inside of the appliance. The following table shows which ambient temperature is correct for each climate classification: SN N ST T +10°C to + 32°C +16°C to + 32°C +18°C to + 38°C +18°C to + 43°C A 10 mm 100 mm It should be located in a dry atmosphere, out of direct sunlight and away from extreme temperature e. g. an outhouse, where the temperatures may fall below 10°C (50°F). You should also ensure that air can circulate freely around the back and the top of the cabinet. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE ZANUSSI ZFK26/11LR




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual ZANUSSI ZFK26/11LR will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.