User manual ZANUSSI TDS473E
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual ZANUSSI TDS473E. We hope that this ZANUSSI TDS473E user guide will be useful to you.
You may also download the following manuals related to this product:
ZANUSSI TDS473E (182 ko)
ZANUSSI TDS473E (192 ko)
ZANUSSI TDS473E (193 ko)
ZANUSSI TDS473E (859 ko)
ZANUSSI TDS473E (218 ko)
ZANUSSI TDS473E (219 ko)
ZANUSSI TDS473E (196 ko)
ZANUSSI TDS473E (197 ko)
Manual abstract: user guide ZANUSSI TDS473E
Detailed instructions for use are in the User's Guide.
[. . . ] Make sure that the appliance does not stand on its electrical supply cable. If the machine is situated on a carpeted floor, please adjust the feet in order to allow air to circulate freely. It should have its own ventilation system which should not be joined with any other ventilation system connected to any other appliance.
s
s
It is dangerous to modify or try to modify the specifications of this appliance in any way. Children should not be allowed to touch the controls or play with the product. [. . . ] As to the outlet itself, if you have decided on a fixed wall/window grille, a good local builder's merchant should be able to supply you with the necessary fittings and installation advice. It is important not to connect the vent hose to, for example, a cooker hood, or a chimney or flue pipe designed to carry the exhaust from a fuel burning appliance.
A P0279
P0055
Note that to avoid condensation problems, it is essential that the dryer be fitted with the flexible hose to carry its "exhaust" at least beyond the kitchen units; preferable outside the kitchen. In order to prevent the appliance from overheating, it is important that the steam exhaust is unobstructed. Therefore, in case of a permanent hose fitted to an exterior wall or ceiling, it must be ensured an exhaust capacity of at least 150 m3/h. If the dryer is fitted next to kitchen units, make sure that the vent hose is not squashed. If the hose is partially squashed, drying efficiency will be reduced, resulting in longer drying times and higher energy consumption. If the hose is completely squashed, the safety cut-outs with which the machine is fitted may operate.
6
Door reversal
To make it easier to load or unload the laundry the door can be reversed. Operate as follows: - Remove the door by unscrewing the two screws (1) fastening the hinge to the cabinet (Fig. - Remove the safety catch (2) and the plug (3) by bending the two fastening tags (Fig. - Refit the safety catch (2) and plug (3) on the door by reversing their positions (Fig. - Remove the plastic plate (4) by unscrewing the two fastening screws (Fig. - Refit the door by screwing in the two screws (1) which fasten the door to the cabinet (Fig. B).
3 2
1
4
P0283
A
2 4 1 3
P0748
B
Electrical connection
This machine is designed to operate on a 220230 V, single-phase, 50 Hz supply. Check that your domestic electrical installation can take the maximum load required (2. 2 kW), also taking into account any other appliances in use. Connect the machine to an earthed socket, in accordance with current wiring regulations. The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precaution.
Stacking kit
A special stacking kit is available through your dealer, to enable the mounting of the dryer on top of your washing machine.
P0280
7
ENGLISH
USE
Control panel
kg 5
A
B
C
kg 2. 5 D
AUTOREVERSE
1
2
3
45
6 78 9
10
1 Programme Chart
This will help you to select the correct programme for drying.
7 End of Programme Light
This light (red) comes on at the end of the drying programme and remains alight until the door is opened. This light will also remind you that the filter should be cleaned at the end of each drying cycle.
2 Low Temperature Button
Press this button to reduce the temperature when drying particularly delicate items. To be used only when drying synthetics with the time controlled programme.
8 Open Door Light
This light (red) flashes when the door is opened or not well closed.
3 Buzzer Off Button
Press this button if you do not wish the buzzer to ring during the anti-crease phase.
9 Mains-On Light
This lights up by selecting the programme or time and goes out when the programme selector dial is turned to 0.
4 Start Button
Press this button for a few seconds to start the selected drying programme. If the door is opened during drying, this button has to be depressed after closing the door to allow the programme to continue.
10 Programme Selector Dial
To set the machine to the selected programme or time, turn the dial until the letter or the time you want coincides exactly with the pointer.
5 Drying Light
This light (green) indicates that the machine is performing the drying programme.
6 Cooling phase Light
This light (green) will illuminate when the cooling phase is in operation. This starts 9 minutes before the end of drying to prevent any creasing or crumpling of fabrics.
8
Electronic Controlled Programmes
These operate by means of dampness sensors. [. . . ] 30 seconds or using the special brief spin programme of your washing machine).
12
MAINTENANCE
You must disconnect the appliance from the electricity supply, before you can carry out any cleaning or maintenance work.
External cleaning
Use only soap and water and then dry thoroughly. From time to time, apply a little wax furniture cream with a soft cloth. Important: do not use methylated spirit, diluents or similar products.
Cleaning the door
Clean periodically the interior part of the door to remove any fluff. Accurate cleaning ensures correct drying.
P0328
Cleaning the filter
Your dryer will only function well if the filter is clean. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE ZANUSSI TDS473E
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual ZANUSSI TDS473E will begin.