User manual ZANUSSI TCS665E
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual ZANUSSI TCS665E. We hope that this ZANUSSI TCS665E user guide will be useful to you.
You may also download the following manuals related to this product:
ZANUSSI TCS665E (676 ko)
ZANUSSI TCS665E (214 ko)
ZANUSSI TCS665E (864 ko)
ZANUSSI TCS665E (221 ko)
ZANUSSI TCS665E (233 ko)
ZANUSSI TCS665E (878 ko)
ZANUSSI TCS665E (205 ko)
ZANUSSI TCS665E (213 ko)
ZANUSSI TCS665E (208 ko)
Manual abstract: user guide ZANUSSI TCS665E
Detailed instructions for use are in the User's Guide.
[. . . ] · If the machine is situated on a carpeted floor, please adjust the feet in order to allow air to circulate freely.
General safety
· It is dangerous to alter the specifications or attempt to modify this product in any way. · Under no circumstances should you attempt to repair the machine yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Always insist on genuine Zanussi spare parts.
Use
· This appliance is designed for domestic use only. [. . . ] Connect the machine to an earthed socket, in accordance with current wiring regulations. The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precaution.
P1043
A
B A B C
P1046
If the appliance is stacked on the washing machine, the condensed water can be discharged through the hose as shown in figure, but take into account that the hose must be pointed downwards.
Door reversal
To make it easier to load or unload the laundry the door can be reversed. Please contact the nearest Zanussi Service Centre.
7
ENGLISH
Use
The control panel
57
ELECTRONIC SENSOR
A
B
C
D
E
F
G
H
TCS
665 E
1 2346
89
10
1 Door opening button
Press this button to open the door: any programme which is running stops.
7 Buzzer OFF light
Comes on when you press the corresponding button.
8 Start button 2 ON/OFF button
This button is used to switch the dryer on. At the end of the programme, release this button by pressing it again to switch the dryer off. Press this button for about 2 seconds to start the dryer after having selected the programme. If the door is opened while the programme is running, this button must be pressed again after closing the door in order to restart the programme from the point at which it was interrupted. This button must also be pressed after a power cut and after having re-inserted the water reservoir if it has been emptied in the middle of a programme. In both cases light or (depending on the phase in progress) flashes to remind you that the start button needs to be pressed again.
3 Mains-ON light
Comes on when the appliance is switched on (ON/OFF button pressed down) and goes out when this button is released.
4 Low temperature button
Pressing this button allows drying to be performed at a lower temperature, for delicate items. If the button is not pressed, drying is performed at full power (2400 W).
9 Programme phase indicator lights
These lights indicate the various phases of the programme as they are being performed.
"Drying" light
This light indicates that the appliance is in the drying phase.
"Cooling" light
5 Low temperature light
Comes on when the low temperature drying button is pressed.
This light indicates that the appliance is in the cooling phase. At the end of drying, there is a 10 minute cooling phase to cool the laundry. If light or is flashing, this means that the Start button needs to be pressed again for the programme to resume.
6 Buzzer OFF button
A buzzer sounds when buttons 4-6 and 8 are pressed and during the anti-creasing phase. Press this button when selecting the programme if you wish to switch the buzzer off. 8
"End of programme" light
This light flashes at the end of the cooling phase and during the anti-creasing phase.
Water full indicator light
This light flashes when the water reservoir is full. In this case, after having fitted back in place, the start button must be pressed again for the programme to resume. There may be dust inside a brand new tumble dryer.
After each use
· Turn the programme selector dial to "0". · Clean the filter and empty the water reservoir (see page 13). If the drying programme has to be stopped before it reaches the end, we recommend that you turn the programme selector dial to position (cooling) and wait until the end of this phase before removing the laundry. Modifying the programme To change a programme which is running, first cancel it by turning the programme selector dial to "0". Please check the laundry does not get caught between the door and filter. If required, press the low temperature button and/or the buzzer OFF button . Press the Start button for 2 seconds: light comes on and drying starts. All drying programmes end with a 10 minute cooling phase (the light is on). [. . . ] After inserting the reservoir the START-button has to be depressed again to allow the programme to continue. Handy tip: The condensed water may be used in a steam iron or to top up a battery, etc. through a coffee filter).
Cleaning the condenser unit
Clean the air condenser periodically, 3 or 4 times a year depending on how frequently the dryer is used. Clean it with a brush and rinse it under the shower if necessary.
P0636
P0639
13
ENGLISH
Something not working?
Before contacting your local Zanussi Service Centre, please make the following checks:
Problem
· The dryer does not work:
Possible cause
· The door is open. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE ZANUSSI TCS665E
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual ZANUSSI TCS665E will begin.