Detailed instructions for use are in the User's Guide.
[. . . ] · Remember to remove all coins, safety pins, boraches, screws, etc. , before each wash. · Do not put articles in your washing machine if you have used a solvent, alcohol, trichloroethylene, etc. , to remove stains from them. If you must use these stain removers, wait until the product has evaporated before putting the articles in the drum. · Collect all small articles such as socks, belts, etc. , in a small cloth bag or pillow case. [. . . ] If it is too short, call a professional.
If you want to keep your washing machine aligned with the adjacent furniture, you can cut the pipe support strip at the back of your washing machine. Electrical connection
You can only connect this washing machine to 230 V single phase power supply. The washing machine must not be connected through an extension cable or a power bar. Check that the earthing connection is conform with the regulations in force.
3. 2. Position
Put the washing machine on a flat hard floor in a well ventilated room. Make sure that your washing machine does not touch the wall or any other furniture in the room. The control panel
1 - «On/Off» pushbutton 2 - «Half load» pushbutton 3 - «Rinse hold» pushbutton Presented model : TA 1050 4 - Spinning speed variator 5 - Programme selector 6 - Temperature selector
123
4
5
6
4. 2. How to do a wash ?
Before the first wash in your washing machine, we recommend that you should do a preliminary wash at 90°C with detergent but without any washing to clean the tub.
The knob indicates the possible spinnings on the coton programmes. These spinnings are reduced for the synthetics, wool and delicate cycles.
4. 2. 4. Choice of the temperature
Choose the wash temperature applicable for the selected programme (using the information given in the programmes table) and comply with the temperature shown on the care label for each article to be washed (see the washing guide).
4. 2. 1. Loading the washing
· · · Lift the machine cover. Open the drum by pressing on the locking button A; the two flaps automatically separate. Insert the washing, close the drum and the cover of your washing machine. Warning : before you close the cover of your washing machine, make sure that the drum door is properly closed: ·the two flaps latched together, ·the locking button A extended.
4. 2. 5. «Half load» pushbutton
This pushbutton allows to wash small quantity of linen not much soiled (max. 2, 5 kg) on cotton programmes only by reducing the water quantity during rinsings.
A
4. 2. 5. 2. Proportioning of detergents
Your washing machine was designed to reduce water and detergent consumption, therefore reduce the doses recommended by detergent manufacturers. Pour the powder detergent dose into the wash compartment and into the prewash compartment if you chose the «prewash» option. Pour in the softener into the compartment and Javel water into the compartment if you wish. If you are using a different type of detergent, refer to the «detergents and additives» section in the washing guide. If you use this pushbutton, the tub remains full of water at the end of the last rinse to prevent the washing from becoming creased if it is not taken out of the drum as soon as the washing machine is stopped.
4. 2. 6. Choice of the programme
Select the programme depending on the nature and the degree of soil of the laundry. [. . . ] the drain siphon is attached too low (see installation section).
The washing machine fills up but empties again immediately: The washing machine will not spin or will not drain:
·
· · · · · · · · · · · · · · · · · ·
the drain pipe is blocked or kinked, the drain filter is blocked, the «Drain» program or the «Rinse hold» option is selected, the height of the drain siphon is wrong. excess detergent has made too much foam that overflowed, the detergent is not suitable for machine washing, the drain siphon is not hooked on properly, the drain filter was not put back into place, the water inlet pipe is leaking. the detergent is not suitable for machine washing, there is too much washing in the drum, the washing program is not appropriate, there is not enough detergent. not all the packing was removed from the machine (see unpacking section), the washing machine is not leveled and properly packed, the washing machine is too close to the wall or furniture, the washing is not well distributed in the drum, the load is not sufficient.
There is water on the floor around the washing machine:
Washing results are not satisfactory:
The machine is vibrating or noisy:
The washing cycle is much too long:
· · · · · · · · ·
the water inlet is blocked, there was a power supply failure or the water was cut off, the motor temperature safety device tripped, the water inlet temperature is lower than normal, the water or electricity supply is defective, a rinse hold was programmed. [. . . ]