User manual VALBERG CIH 90 EGK 302C

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual VALBERG CIH 90 EGK 302C. We hope that this VALBERG CIH 90 EGK 302C user guide will be useful to you.


VALBERG CIH 90 EGK 302C : Download the complete user guide (2026 Ko)

Manual abstract: user guide VALBERG CIH 90 EGK 302C

Detailed instructions for use are in the User's Guide.

[. . . ] It is necessary to refer to the diagram of this manual to comply with the following points: - Dimensions of the space to be provided for the appliance. - Dimensions and position of the means used to support and fasten the appliance in this space. - Minimum clearance between the different parts of the appliance and the surrounding structure. If the power cable is damaged, it must be replaced by the manufacturer, its after-sales department or similarly qualified persons to avoid any danger. [. . . ] Installation If you have an external evacuation, you can connect your extractor hood as illustrated below using an extraction duct (flexible tube made from aluminium, enamel or other non-flammable material tube with an internal diameter of 150 mm). Switch off the appliance and disconnect from the mains prior to installation. For optimum results, the extractor hood should be installed at a distance of 65 to 75 cm above the cooking surface. After deciding on the height of the extractor hood, measure the position of the holes required to suspend the hood as well as the inner duct mount. Drill 4 holes of 8: 2 for the inner duct mount and 2 others to suspend the hood, while making sure it is properly levelled. The position of the inner duct mount corresponds to the location of the duct. Screw two 4 x 30 mm screws to the wall using dowels to secure the hood, then use two 4 mm x 40 mm screws to secure inner duct mount. Install the outer duct mount using 2 ST4*8mm screws, ensuring that the inner duct remains flexible. Suspend the hood from the wall by adjusting its position and fix the extractor hood using 2 ST4*30 mm safety screws. COMMENT : The two safety vents are placed on the rear cover and have a 6 mm Adjust the height of the inner duct relative to the position of the inner duct mount and fix it all using 2 ST4*8 mm screws. Recommendations for installation of the evacuation duct The following rules must be strictly followed, in order to obtain optimal air extraction: ?If you use a flexible pipe, always install it so that it is properly stretched out to limit pressure losses. Failure to comply with these basic instructions will reduce the performance of the hood and increase its noise level. All installation work must be carried out by a qualified electrician or a competent person. Do not connect all the ducts in the hood to an existing ventilation system that is used for another device, such as heating, gas or hot air ducts. The angle of curvature of the ventilation duct shall not be less than 120º; you need to position the duct horizontally. Otherwise, raise the pipe vertically from the entry point and guide it towards an outside wall. Once the installation is complete, check that the extractor hood is level to avoid any accumulation of grease on one end. Ensure that the evacuation duct chosen for the installation meets applicable standards and is flame retardant. WARNING : For safety reasons, please only use fastening or mounting screws with The dimensions recommended in this user manual. Any non-compliant installation of the screws or fastening devices with these instructions presents an electrical hazard. Turning on the appliance: once the extractor hood has been connected to the main power supply, the backlighting of all the buttons will come on. [. . . ] COMMENT : All electrical repairs to this appliance must comply with your local, state and federal legislation. Always unplug the appliance from the power source if you need to open it. DISPOSING OF PACKAGING MATERIALS Packaging materials protect your appliance from damage that may occur during transport. These materials are environmentally friendly since they are recyclable. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE VALBERG CIH 90 EGK 302C




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual VALBERG CIH 90 EGK 302C will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.