User manual TEFAL ULTRAGLIDE DIFFUSION

[. . . ] - Obtaining more steam for removing wrinkles (depending on the model) ULTRAGLIDE DIFFUSION Shot of Steam Button (depending on model) for removing wrinkles - Press the shot of steam button from time to time (I). - Wait a few seconds between each shot before pressing the button again. Vertical steam ironing (depending on the model) I Auto-Stop safety warning light Spray Button to moisten linen Water tank filler cover Steam control (depending on model) - Hang up the garment on a hanger and hold the fabric slightly taut with one hand. - Press the shot of steam button ( ) repeatedly (K), moving the iron from top to bottom (L). [. . . ] - Fill the water tank up to the limit (see recommendations for the types of water to use). - Shake the iron gently, over the sink, until all of the water in the water tank (with the impurities) has flowed out via the sole plate. - At the end of the operation, push the anti-calc valve back into position. - Turn the iron back on for 2 minutes, setting it on its heel, to dry the sole plate. - Unplug the iron, and when the soleplate is just warm, wipe it with a soft cloth. Recommendation : The self-cleaning function helps to delay the scaling of your iron. 4- STORING YOUR IRON - Unplug it and wait until the sole plate has cooled off. The voltage of your electrical installation must correspond to that of the iron (220V-240V or 127 V depending on the model). Connecting to the wrong voltage may cause irreversible damage to the iron and will invalidate the guarantee. · If using a mains extension lead, ensure that it is correctly rated (10A or 13A for UK only), with an earth. · If the electrical cord becomes damaged, it must be immediately replaced by an Approved Service Centre to avoid any danger. · The appliance must be unplugged before filling or emptying the water tank. · If the appliance falls, have it checked by a professional before using it again; unseen damage may be dangerous. - Never leave your iron unattended when it is plugged in or while the soleplate is still hot. · NEVER DISMANTLE YOUR IRON ; ALWAYS CONTACT AN APPROVED SERVICE CENTRE. Any professional use, inappropriate use or failure to comply with the instructions, the manufacturer accepts no resposibility and the guarantee will not apply. GUARANTEE (U. K. [. . . ] · The wire that is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK. · Should the fuse need to be replaced an ASTA marked fuse, approved to BS 1362, of the same rating must be used. · Always replace the fuse cover after fitting a fuse. The plug must NOT be used if the cover is omitted or lost until a replacement is obtained ­ make certain that only the correct fuse cover is used and fitted. [. . . ]