User manual SAMSUNG VR30T80313W/WA

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual SAMSUNG VR30T80313W/WA. We hope that this SAMSUNG VR30T80313W/WA user guide will be useful to you.


SAMSUNG VR30T80313W/WA : Download the complete user guide (25656 Ko)

You may also download the following manuals related to this product:

   SAMSUNG VR30T80313W/WA (759 ko)
   SAMSUNG VR30T80313W/WA (701 ko)
   SAMSUNG VR30T80313W/WA (1613 ko)
   SAMSUNG VR30T80313W/WA (794 ko)
   SAMSUNG VR30T80313W/WA (511 ko)
   SAMSUNG VR30T80313W/WA (1739 ko)
   SAMSUNG VR30T80313W/WA (982 ko)

Manual abstract: user guide SAMSUNG VR30T80313W/WA

Detailed instructions for use are in the User's Guide.

[. . . ] For the normal use of the Jet Bot's functions, the SmartThings connection is required. Pre-motor Filter: 2 units (Inside the product: 1 unit, Spin Brush: 2 units (Inside the product: 1 unit, Install the Docking Station in a place where the floor and wall are level. If the Battery Charger cord is too long for the installation environment, coil the power cord around the cable management post, then put it in the fixing groove at the rear of the Docking Station. Open the upper cover of the Jet Bot and Remove the yellow gasket attached to the Power switch at the side of the Jet Bot and press the power switch to turn the Jet Bot on. [. . . ] Do not put any objects on top of the Jet Bot since it may cause malfunction of the LiDAR sensor or the Jet Bot. When the power cord is damaged, contact a service center to get it replaced by a certified repairman. Please check with a SAMSUNG Electronics service center when replacing batteries. - Do not clean the Jet Bot by spraying water directly onto it or use a volatile substance such as benzene, thinner, or alcohol to clean it. Always keep the Obstacle Sensor Window and the Cliff Sensor Window clear. Be careful that the LiDAR sensor is not Exposed to a direct light such as sun light, infrared light, etc. - The direct light can affect the performance When carrying the Jet Bot, be careful not to let it drop. - The impact from the drop can affect the Do not look at the transmitting part (a laser) of the revolving LiDAR sensor horizontally. Be careful not to insert a tool such as a chopstick into the revolving LiDAR sensor. Before cleaning, remove objects which are less than 9 cm height and are lightly on the floor as the Jet Bot can push along them, or the objects can be caught in the Jet Bot's spin brush or driving wheels. The Jet Bot cannot vacuum clumps of dirt, so some may remain on the floor after cleaning. After turning the Jet Bot off, wait for a while and then turn it on for a normal rebooting. If you washed the Dustbin and filter with water - Dustbin: Completely wipe out the water. Watch your fingers when attaching or detaching the filter, since they may get stuck in the Dustbin's intake. To avoid blockages by foreign matter, do not let the Jet Bot vacuum up toothpicks, cotton swabs, etc. If it is difficult to remove foreign matter from the brush, contact an authorized SAMSUNG service center. Since the brush sweeps dirt up from the floor during cleaning, foreign matter such as a thin and long thread, long hair, etc. If a brush or a brush cover is not assembled correctly after the maintenance work, scratches may occur on the floor, or product malfunction may occur. Therefore, assemble them correctly by checking the maintenance method. When you purchase a battery, check the Battery and the model name, then contact a This battery is exclusively for the SAMSUNG Electronics Jet Bot. If the battery malfunctions, do not As the battery is used over a length of time, the battery charging time and usage time decreases. In this case, contact a service center and replace it with a new battery. [. . . ] Correct disposal of batteries in this product (Applicable in countries with separate battery return systems. ) The marking on the battery, manual or packaging indicates that the battery in this product should not be disposed of with other household waste. Where marked, the chemical symbols Hg, Cd or Pb indicate that the battery contains mercury, cadmium or lead above the reference levels in EC Directive 2006/66. For information on its replacement, please contact your service provider. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE SAMSUNG VR30T80313W/WA




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual SAMSUNG VR30T80313W/WA will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.