User manual MELICONI SPEEDY GOAL PLUS

[. . . ] Thank you for choosing Meliconi. This simplified universal remote control contains all the main functions of most TV remote controls on the market. ON/OFF to turn OFF your TV and, in some cases, to turn ON your TV. Identify and take note of the TV code which you have searched for, following the code noting procedure (see "PROGRAMMED CODE NOTING" section). NOTE: DURING THE SEARCH OPERATION, THE LIGHT INDICATOR FLASHES MORE QUICKLY. THE LIGHT INDICATOR STOPS FLASHING AND YOUR REMOTE CONTROL LEAVES PROGRAMMING MODE IN THE FOLLOWING CASES: · if no keys are pressed for 12 seconds · if you press keys other than those indicated · if the code search list is completed. [. . . ] Note the sequence of the 9 flashes and note them down on the label in the battery compartment cover, from left to right. RE-PROGRAMMING YOUR REMOTE CONTROL BY ENTERING THE CODE NOTED DOWN If the remote control is no longer programmed because it has been left without batteries for a long time or has flat batteries, you can re-program it quickly as follows: 1. Hold down the and keys simultaneously until the light indicator at the top starts to flash indicating that the remote control is programming. Release the keys and, within 12 seconds, using the and keys, enter the nine-sign code which you noted down before. At the end, three flashes indicate that the code has been saved correctly. If not, try the code entry procedure again from point 1. To select an external terminal. Mute key. SET-UP Read these instructions carefully before programming your remote control!To use the remote control with your appliances, you must first program Speedy Goal Plus as described below. You can also visit our Internet site www. meliconi. com to have access to interactive instructions for easier and faster remote control programming. Hold down the and keys simultaneously until the light indicator at the top starts to flash indicating that the remote control is in programming mode. When you release the keys, three flashes indicate that the search operation has been completed correctly. If the commands work incorrectly or erratically, you have probably entered a code for a similar but different remote control. In this case, repeat the search procedure from point 2 until all keys respond correctly to the commands sent. IF YOU DO NOT HAVE THE PROGRAMME SELECTION KEYS ON YOUR ORIGINAL REMOTE CONTROL If your remote control does not have the programme selection keys (e. g. / , +/-, CH+/-. . etc) once you have programmed Speedy Goal Plus, you can still select the programmes from 0 to 9, as follows: · Hold down the and keys simultaneously until the light indicator starts to flash indicating that the remote control is in programming mode. Three flashes indicate that the operation has been completed correctly. [. . . ] In this case, set the code (press 9 times) as described in the PROGRAMMING YOUR REMOTE CONTROL section above. To return to programme 1 directly, press INFO LINE If you have any queries about Speedy Goal Plus: · read this booklet carefully ­ this will help you to solve almost all problems · consult our Internet site www. meliconi. com to answer all your queries more easily and quickly. WARRANTY: 2 years The warranty ceases to be valid if the product is tampered with or used incorrectly. Remote control model Speedy Goal Plus Purchase date___________________ [. . . ]