User manual MELICONI FULLY 8

[. . . ] ⷠMake a note of the code for your appliances on the adhesive label supplied inside the battery cover. Read these instructions carefully before programming your remote control!To command your appliances, you must program your FULLY 8 as described below in A or B . [. . . ] Additional check Check that some of the other functions used on your original remote control are working correctly. If the commands function incorrectly or erratically, you have probably entered a code for a similar but different remote control. Identify and take note of the code which you have searched for following the code noting procedure NOTE: during the search operation, the light indicator flashes more quickly. The light indicator stops flashing and the remote control leaves the programming mode in the following cases: · If no keys are pressed for 12 seconds · This operation may take a few minutes. Hold down the selection key for the appliance to be programmed for 5 seconds ( TV . ADSL ), until the light indicator at the top starts to flash indicating that the remote control is ready for programming. The light indicator flashes more quickly to indicate that the remote control is ready for the search. Press and slowly release the key several times or for the VCR and DVD. Stop when the appliance responds correctly to the command transmitted. When the appliance responds correctly, press the OK key to confirm the selection. three long flashes indicate that the operation has been completed correctly. Additional check Check that some of the other functions used on your original remote control are working correctly. If the commands function incorrectly or erratically, you have probably entered a code for a similar but different remote control. Identify and make a note of the code which you have searched for following the code noting procedure Remember to note down always the 4-digit code for the appliances, located under the battery cover, when the search and programming are complete. The codes will be required if the remote control must be re-programmed following accidental deletion. Press the select key for which you want to know the code and hold down for 5 seconds ( TV . [. . . ] Set the remote control code, following the global search programming procedure B . The code for your appliance brand is not in the list of codes of the end of this booklet. If you have further questions concerning the FULLY 8 remote control unit, visit www. [. . . ]