User manual LIFT-MASTER 88LM
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual LIFT-MASTER 88LM. We hope that this LIFT-MASTER 88LM user guide will be useful to you.
Manual abstract: user guide LIFT-MASTER 88LM
Detailed instructions for use are in the User's Guide.
[. . . ] [. . . ] 18" Wire
PRE-WIRING FOR SAFETY SENSOR SYSTEM 2-Conductor Wire (white and white/black) on each side of garage door, exiting wall
Figure 2
Figure 3
Pre-Wiring White
Terminal Screws White
Sensor Unit
Safety Sensor White Tab
White/Black
White/Black Sensor Wiring (4 Ft. ) Connector
Terminal Block
Separate and strip 1/4" of insulation from the 2-conductor wire exiting the wall on each side of the garage door. Tighten the terminal screws.
Insert the connector end of the bell wire supplied into the sensor and push until you hear a click. The white tab on the sensor should be flush with the back of the connector. Attach the other end of the wire to the terminal block following the procedure as described and shown in Figure 2.
114A1670
© 1993, The Chamberlain Group, Inc. [. . . ] [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE LIFT-MASTER 88LM
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual LIFT-MASTER 88LM will begin.