User manual LIFT-MASTER 59LM
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual LIFT-MASTER 59LM. We hope that this LIFT-MASTER 59LM user guide will be useful to you.
Manual abstract: user guide LIFT-MASTER 59LM
Detailed instructions for use are in the User's Guide.
[. . . ] KEY SWITCH INSTALLATION INSTRUCTIONS
FOR SECTIONAL DOORS (FOR ONE-PIECE DOORS Refer to Page 2)
WARNING CAUTION
WARNING
To prevent possible SERIOUS INJURY or DEATH from electrocution, disconnect power to opener BEFORE proceeding.
Step 1: Disconnect power to operator. [. . . ] CAUTION: Bell wire should be pulled taut to prevent access to wiring from outside the garage.
(3)
Step 2: (Illustration 2). If your garage has a built-up jamb, drill the hole to a depth of 2" (5 cm). Then on the inside jamb, drill a second hole into the first hole to complete access.
Mounting Plate
Nail
(2)
Door Track Bell Wire
Terminal Screw
Door Jamb
1" (2. 5 cm) Diameter Hole
Step 4: If screw nails won't hold the plate firmly in place, use anchor and nut supplied with hardware. Drive a nail into jamb and wind some wire around it before connecting to terminals on back of opener. NOTE: Instructions for attaching the bell wire to opener are on page 2 (illustration 5).
2" (5 cm) Min.
1
KEY SWITCH INSTALLATION FOR ONE-PIECE DOORS
STEP 5: (illustration 4). Install Key Switch in the exterior away from door opening to avoid injury as door swings out and up. Insert switch in hole and fasten in place with screw nails and/or anchor and nut hardware. Drive a nail into jamb and wind some wire around it before connecting to the terminals on the back of the opener. [. . . ] Locate the terminal illustration which matches your opener and attach bell wire as shown.
(4)
Exterior Wall Drill 1" Diameter Hole
(4) Screw Nails One Piece Door Movement
Door Jamb See Note 1
Key
(5)
Key Switch Terminal Screw Nut Anchor Key Switch Plate
WHT WHT BLK
RED
WHT BLK
RED
WHT BLK
YEL
RED WHT BLK ORG YEL
3-Screw Terminal Attach Bell Wire to WHT & WHT Terminals
3-Screw Terminal Attach Bell Wire to RED & WHT Terminals
4-Screw Terminal Attach Bell Wire to RED & WHT Terminals
5-Screw Terminal Attach Bell Wire to RED & WHT Terminals
114A0203M
©2006, The Chamberlain Group, Inc. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE LIFT-MASTER 59LM
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual LIFT-MASTER 59LM will begin.