User manual GE GDF520DWW

[. . . ] Write the model and serial numbers here: You can find them on the tub wall just inside the door. For your safety, the information in this manual must be followed to minimize the risk of fire, Under certain conditions, hydrogen gas may be produced in a water heater that has not been used for two or more weeks. If the hot water has not been used for two or more weeks, prevent the possibility of damage or injury by turning on all hot water faucets and allow them to run for several minutes. Do this before using any electrical appliance connected to the hot water system. [. . . ] To adjust the upper rack, fully extend the upper rack and remove the two plastic end caps on the front of the rails. Select the set of rollers on the side of the rack that provides the desired height, and reinstall the upper rack by guiding the rack rails between the appropriate set of rollers. With the rack reinstalled, replace the two plastic end caps, ensuring the snap is properly engaged. Failure to properly engage the end caps may result in the rack falling from the dishwasher. To add flexibility in loading, the utility shelf (on some models) may be placed in the up or down position. Because these stemware items come in various sizes, slowly push the rack in to ensure the items do not bump into the edges of the dishwasher, which may cause damage to the items. It is important to ensure that items do not protrude through the bottom of the rack or silverware basket (on some models) where they will block the rotation of the middle spray arm. This could result in noise during operation and/or poor wash performance. Check to make sure that no items will block rotation of the wash arms. The lower rack is best used for plates, saucers and Fold down tines (on some models) allow for greater Large items, such as broiler pans flexibility in loading large items. And baking racks should go along the sides of the of the fold down tine that best accommodates If necessary, oversized glasses and mugs can your dishware items. The direction of the fold down Tines can be changed to match preferred loading To adjust the fold down tine direction, Placed between the tines in the direction that allows remove the clips securing the fold down tines to the The item to remain secure in the rack. Racks by sliding the clip so that it disengages from Do not load large items where they may block the detergent dispenser when the door is closed. The fold down tines may be rotated in the opposite direction to reverse the loading The reversible tine blocks (on some models) are designed to allow greater flexibility in loading dishes. The direction of the tine blocks can be changed to match preferred loading direction. To adjust the tine block direction, remove the clips securing the tine Secure the fold down tines to the rack using the same clips. The clip is removed by pulling up on the clip and separating it from the rack. Replace the clip on the opposite side of the rack by positioning the clip over the wire and pressing down. Blocks to the racks by pulling up on the tab, then It is important to ensure that items do not protrude Flex the retaining wire to unseat the tine block from through the bottom of the rack or the silverware The tine block may be turned in the opposite direction to reverse the loading direction. Secure the tine block to the rack using the same process and be sure to snap the same clips in place. This could result in noise during operation and/or poor wash performance. Features and appearance of racks and silverware baskets may vary from your model. [. . . ] You are responsible for providing adequate electrical, exhausting and other connecting facilities. Failure of the product if it is abused, misused, or used for other than the intended purpose or used commercially. Any implied warranties, including the implied warranties of merchantability or fitness for a particular purpose, are limited to one year or the shortest period allowed by law. This warranty is extended to the original purchaser and any succeeding owner for products purchased in Canada for home use within Canada. [. . . ]