User manual DYNATEK D3K3-3

[. . . ] All parts which ensure the safe operation of the appliance must not be removable without the aid of a tool. 2 Electrical connections !Ovens equipped with a three-pole power supply cable are designed to operate with alternating current at the voltage and frequency indicated on the data plate located on the appliance (see below). Open the terminal board by inserting a screwdriver into the side tabs of the cover. Use the screwdriver as a lever by pushing it down to open the cover (see diagram). [. . . ] Once the cooking has been completed, the cooling fan remains on until the oven has cooled down sufficiently. It stays on when a cooking mode is selected. G B Starting the oven 1. See the Cooking advice table for cooking modes and the suggested cooking temperatures (see Cooking Modes). When preheating is finished, the THERMOSTAT indicator light will stay on: place the food in the oven. You may do the following during cooking: - change the cooking mode by turning the SELECTOR knob. Never put objects directly on the oven bottom to avoid damaging the enamel coating. Always place cookware on the rack(s) provided. 5 Cooking modes GB Cooking modes !A temperature value can be set for all cooking modes between 60°C and Max, except for • BARBECUE (recommended: set only to MAX power level); • GRATIN (recommended: do not exceed 200°C). @ BARBECUE mode The top heating element comes on. The high and direct temperature of the grill is recommended for food that requires high surface temperature. Always cook in this mode with the oven door closed. A GRATIN mode = TRADITIONAL OVEN mode Both the top and bottom heating elements will come on. With this traditional cooking mode, it is best to use one cooking rack only: if more than one rack is used, the heat will be distributed unevenly. K BAKING mode The rear heating element and the fan come on, guaranteeing the distribution of heat delicately and uniformly throughout the oven. Use the “+” and “-” buttons to set the desired time; if you press and hold either button, the display will scroll through the values more quickly, making it quicker and easier to set the value. Wait for 10 seconds or press the button again to finalise the setting. When this period of time has elapsed the buzzer will be activated. 8 Precautions and tips !The appliance was designed and manufactured in compliance with international safety standards. The following warnings are provided for safety reasons and must be read carefully. • The appliance should not be operated by people (including children) with reduced physical, sensory or mental capacities, by inexperienced individuals or by anyone who is not familiar with the product. These individuals should, at the very least, be supervised by someone who assumes responsibility for their safety or receive preliminary instructions relating to the operation of the appliance. • Do not let children play with the appliance. G B General safety • The appliance was designed for domestic use inside the home and is not intended for commercial or industrial use. • The appliance must not be installed outdoors, even in covered areas. It is extremely dangerous to leave the appliance exposed to rain and storms. • When handling the appliance, always use the handles provided on the sides of the oven. [. . . ] • Always keep the oven door closed when using the BARBECUE and GRATIN mode to attain best results and to save energy (approximately10%). • Regularly check the door seals and wipe clean to ensure they are free of debris so that they stick properly to the door and do not allow heat to disperse. Assistance Communicating: • appliancemodel(Mod. ) • serial number (S/N) This information is found on the data plate located on the appliance and/ or on the packaging. 9 Maintenance and care G B Switching the appliance off Disconnect your appliance from the electricity supply before carrying out any work on it. Inspecting the seals Check the door seals around the oven periodically. If the seals are damaged, please contact your nearest Aftersales Service Centre (see Assistance). We recommend not using the oven until the seals have been replaced. Cleaning the appliance • The stainless-steel or enamel-coated external parts as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and neutral soap. [. . . ]