User manual DOMETIC L-2963 SUPPLEMENTAL INSTALLATION GUIDE FOR NEW QUICK-CONNECT COUPLINGS
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual DOMETIC L-2963. We hope that this DOMETIC L-2963 user guide will be useful to you.
Manual abstract: user guide DOMETIC L-2963SUPPLEMENTAL INSTALLATION GUIDE FOR NEW QUICK-CONNECT COUPLINGS
Detailed instructions for use are in the User's Guide.
[. . . ] Adler/Barbour
Supplemental Installation Guide For New Quick-Connect Couplings
This supplemental installation guide provides information about the new Quick-Connect self-sealing couplings currently shipping with Adler/Barbour products but not yet covered in the manual Adler/Barbour Installation Guidelines For Cooling Units and Evaporators (L-2488)
S5
S2
New Self-Sealing Quick-Connect Couplings
CHANGE
OF
COUPLING TYPE
Previously - The Adler/Barbour cooling unit and evaporator were connected with one-shot, all-metal, piercing-type couplings. [. . . ] During this stage, both coupling halves are still completely sealed, preventing leakage of refrigerant. When fully connected, continued tightening of the union nut (female coupling) draws the couplings together, and opens the fluid passage by forcing the male coupling's poppet assembly and the female coupling's sleeve assembly open. When fully coupled, a metal ring located in the front of the male coupling forms a leak-free metal-to-metal seal between the two coupling halves. 1 L-2963 ENGLISH
Supplemental Installation Guide For New Quick-Connect Couplings
INSTALLATION PROCEDURE
Refer to the diagram at the top of page 1. Leaving plastic caps and plugs in place, carefully wipe off the fittings to remove dirt, dust and moisture. Drill holes in bulkhead or panel to accommodate the coupling half if necessary. Remove dust caps and plugs if used, making sure that component synthetic seals are intact. Wipe off coupling seals and threaded surfaces with a clean cloth to prevent the inclusion of dirt or any foreign material in the system. [. . . ] If a torque wrench is used, tighten to 10-12 foot pounds.
Connect the upper refrigerant male to female couplings following the same procedure described above.
2
L-2963 ENGLISH [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE DOMETIC L-2963
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual DOMETIC L-2963 will begin.