User manual CANDY CDW 252 ALTERNATIVE

[. . . ] Thus excellent washing results are guaranteed while optimising water and energy consumption. After pressing the "ON/OFF" button, the LED for the factory set is "recommended" (which is ideal for full load daily use) or the LED for the "Auto' Memory" program (see below) will blink. IMPORTANT The dishwasher has two very practical functions: ( the "recommended" program ) for quick and sure selection; Hold down the current program button (with the LED on) for at least 5 seconds. The display will go blank and the program end LED will turn on in the display At this point a new program can be set. [. . . ] IMPORTANT All options MUST be turned on or off, BEFORE starting the program. - the "Auto' Memory", function which saves a program used at least 3 times consecutively so that if you regularly use the same washing cycle each time you do not have to continually set the program thereby saving time and effort. to select an option , press the corresponding button (the LED will turn on). Option buttons must be pressed BEFORE starting the program for them to be accepted. The program starts automatically, the relevant LED will stop blinking and remain on and the cycle length will appear on the display. If the previously described operations were performed with the door open, the program will not start until the door is closed. Before starting a new programme, you should check that there is still detergent in the dispenser. If there is any break in the power supply while the dishwasher is operating, a special memory stores the selected programme and, when the power is restored, it continues where it left off (if it is necessary, the appliance will make a short thermal anti-shock programme before). "ECO" button The "ECO" button provides over 20% time and energy savings by reducing the final water heating and drying times during the last rinse cycle. This option is recommended for light soil washes, and for when the dishes are not required perfectly dry straight away. If you want to get better drying, we advise to leave the dishwasher door slightly ajar at the end of the cycle, to allow for a natural circulation of air inside the dishwasher. The waterblock system has been designed to improve the safety of your appliance, particularly when the machine is left unattended. The waterblock system actually prevents flooding which might be caused by a machine malfunction or as a result of a fracture on the pipes. How does waterblock work The sump located in the base of the appliance collects any possible water leakage and operates a sensor which subsequently activates a valve placed under the water tap and stops any water from the supply even with the tap fully opened. If the box containing the electrical parts is damaged, remove the plug from the socket immediately. To ensure perfect operation of the safety system, box "A" with the hose, should be connected to the tap as shown in figure "1". If the hose is not long enough for correct connection, it must be replaced with a longer one. This dishwasher is also equipped with an anti-overflow safety device which, if water exceeds normal levels due to malfunctions, automatically blocks water flow and/or drains excess quantities. Depending on the source of the supply, water contains varying amounts of limestone and minerals which are deposited on the dishes leaving whitish stains and marks. The higher the level of these minerals present in the water, the harder the water is. The dishwasher is fitted with a water softener unit which, through the use of special regenerating salt, supplies softened water for washing the dishes. The degree of hardness of your water can be obtained from your water supply company. [. . . ] When you have reached "d7", the display will go back to "d1". When the required setting appears on the display, wait for an audible signal to confirm that the new setting has been stored in memory. The water softener can treat water with a hardness level of up to 90°fH (French grading) or 50°dH (German grading) through 8 settings. With cold water (15°C)** -Tolerance ± 10%Hot rinse with rinse aid Wash with prewash If setting the INTENSIVE wash programme, a second dose of about 20 g of detergent (1 table-spoon) must be added directly in the machine. [. . . ]